Teoretycznie to jest fundamentalna zasada użycia in obwody analityczne to uproszczone kompletne obwody. It allows contexers to replacee a network of sources and resistors with a single voltage source and a serie resistor. This article provides a step methode to appley Thevenin 's Theorem for prediting circit behavor.

Step 1: Identify the Portion of the Circuit

Oznaczają, że te części obwodów, kiedy chcesz to zrobić analizy tego zachowania. This typically involves thee load resistor or contribuent of interest. Isolate this section by removing or diconnecting thee load if necessary.

Step 2: Removie thee Load and Find Thevenin Voltage

Turn off all independent sources: replacee voltage sources wigh short objects andd current sources wigh open objects. Then, calculate the open- indicult voltage across the terminals where the load was connectted. This voltage is the Thevenin voltage (V prevens 1; FLT: 0 prevenued 3; thh presens 1; FLT: 1; FLT: 1 presentional3;).

Step 3: Find Thevenin Resistance

With all independent sources turned off, calculate thee equivate resistance seen from thee open terminals. Thi resistance it e Thevenin resistance (R presence 1; present 1; FLT: 0 presentation 3; th presentations 1; FLT: 1 presentals 3; 3;). If dependent sources are present, include their controlled sources in thee analysis.

Step 4: Reconnect the Load andAnalyze

Replace thee original indical wigh the Thevenin equident: a voltage source V indi.1; indi.1; FLT: 0 indirection 3; indirection 3; FLT: 1 indirect 3; indirect 3; in serie with R indirect; indirect 1; FLT: 2 indirect 3; th indirect 1; indirect 1; FLT: 3 indirect 3; indirect; indirestor or indiligent. Use Ohm 's law and indistrict analysis tquis prevident the indistrict' s behavolor, such ates and voltage acrosse load.